Plz-3w/3wh series, Electronic load (cc·cr·cv·cp), Front panel – Atec Kikusui-PLZ1003W User Manual

Page 2: Rear panel

http://www.kikusui.co.jp/

Page2

Front Panel

PLZ-3W/3WH series

ELECTRONIC LOAD (CC·CR·CV·CP)

PLZ303WH

Rear Panel

1 Load terminals on the front panel

Used to connect to the device being tested. They are connected in paral
lel to the load terminals on the rear panel. (Note that PLZ603W/603WH
and PLZ1003W/1003WH have no load terminals on the front panel.)

2 LOAD key

Turns on/off current that flows through the instrument.

3 Screen (LCD with back light)

Displays the set values of current, resistance, voltage, and power; menu
items; and a variety of parameters and messages.

4 Constant current (C.C) / constant resistance (C.R) lamps

Indicate whether the instrument is in C.C or C.R mode.

5 Function keys

Used to select each mode, or to set memories or rise/fall time.

6 JOG/SHUTTLE knobs

The JOG knob is used for fine adjustments to set values or to select val
ues, and the SHUTTLE knob is used for coarse adjustments to set values.

7 Arrow keys

Used to select a menu, setting item, or a step number for program editing
in the sequence mode.

8 Sequence keys

Menu keys for sequence mode

9 Memory card slot

An optional memory card (SMC-32) is inserted here.

10 Contrast control
11 Optional board slot

An optional interface board (one of GPIB, RS-232C, and MCB) is in
serted here.

12 Remote sensing terminals

Used for remote sensing that compensates for the voltage drop caused by
resistance in load cabling.

13 External control connector
14 Load terminals
15 AC input supply voltage range selector switch (on the bottom face)

4
5

PLZ303WH