Atec Mitutoyo-SJ-410 - Manual (Page 6)

6
Optional Accessories
Three new optional products are available to be attached to the manual column stand (No.178-039). You can choose the unit that suits your application.
Or, you can also use the three products in any combination. Using the optional units makes SJ-411/412 more convenient and easier to use to ensure
accurate measurements.
Can be adjusted to match the height of the item to be measured.
Options for simple column stand
Simple column stand
12 120 40
60
578
250 400
15
8.5
7 11
No.178-039
Vertical adjustment range: 250mm
Dimensions: 400Ч250Ч578mm
Mass: 20kg
* Cannot be used when the tester’s main
unit is an older model (SJ-401/402).
• Auto-set unit (178-010)*
This unit enables the vertical (Z axis) direction to be positioned
automatically (auto-set function).
A single button operation completes a series of operations from
measurement, saving and auto-return (saving and auto-return can be
switched on and off by operating the drive unit).
• Tilting adjustment unit (178-030)*
This unit is used for aligning the workpiece surface with the detector
reference plane. It supports the DAT function to make the leveling of
workpiece surfaces easier.
• X-axis adjustment unit (178-020)*
This unit helps fine-tune the horizontal (X axis) direction.
Preliminary measurement
Tilt adjustment
Complete set of optional
units for the manual
column stand
Tilting adjustment unit
X-axis adjustment unit
Auto-set unit
10mm
12.5mm 12.5mm
±1.5°
Dimensions
Unit: mm
T-groove dimensions