Atec Espec-ESX Series - Manual (Page 14)

TSE-11 Thermal Shock
Simple to install and operate
Get a thermal shock chamber without the hassles. Our TSE-11-A is compact and
easy to operate, while still meeting industry test standards. Only 26 inches
wide, the TSE-11 transfers product loads between cold and hot zones with a
temperature range of -65
°
C to 200
°
C.
• Meets strict Mil-Std 883 thermal cycling requirement for
product-temperature recovery.
• Touch-screen operation is very easy, yet full-featured.
• Diagnostic alarms with on-screen help make troubleshooting quick and easy.
• The cold zone is cooled by refrigeration. No need for tanks of
liquid nitrogen (or cooling water either).
TSE-11 (26"w x 42"d x 64"h exterior)
13 Go ESPEC: www.espec.com
Temperature Temperature Temperature
Model Range Range Recovery Time Test Load
Performance Example
Hot zone:
60 to 200
°
C
(140 to 392
°
F)
Cold zone:
-65 to 0
°
C
(-85 to 32
°
F)
• Catalog available
-65
°
C to 150
°
C
Mil-Std 883E
method 1010.7
Method C
5 minute supply air
or
15 minute worst case
product, per 1010.7
4 kg (8 lb.)
plastic ICs
TSE-11-A
Interior Interior Dimensions
Volume WxDxH
11 L 32x23x15 cm
(.4 cu. ft.) (12.5x9.1x5.8 in)