Atec Anritsu-MT8220T - Manual (Page 7)

BTS Master™ MT8220T Specifications
MT8220T TDS PN: 11410-00698 Rev. B 7 of 28
Coverage Mapping (Option 0431)
Measurements
Indoor MappingRSSI, ACPR
Outdoor MappingRSSI, ACPR
Setup Parameters
Mode Spectrum Analyzer
Frequency Center/Start/Stop, Span, Freq Step, Signal Standard, Channel #, Channel Increment
Amplitude Reference Level (RL), Scale, Attenuation Auto/Level, RL Offset, Pre-Amp On/Off, Detection
Span Span, Span Up/Down (1-2-5), Full Span, Zero Span, Last Span
BW RBW, Auto RBW, VBW, Auto VBW, RBW/VBW Ratio, Span/VBW Ratio
Measurement Setup ACPR, RSSI
Point Distance / Time Setup Repeat Type Time Distance
Save Points Map Save KML, JPEG, Tab Delimited
Recall Points Map Recall Map, Recall KML Points only, Recall KML Points with Map, Recall Default Grid
Interference Analyzer (Option 0025)
Measurements
Spectrum Field Strength
Occupied Bandwidth
Channel Power
Adjacent Channel Power Ratio (ACPR)
AM/FM/SSB Demodulation (Wide/Narrow FM, Upper/Lower SSB), (audio out only)
Carrier-to-Interference ratio (C/I)
Spectrogram Collect data up to one week
Signal Strength Gives visual and aural indication of signal strength
Received Signal Strength Indicator (RSSI) Collect data up to one week
Signal ID ID up to 12 FM, GSM, W-CDMA, CDMA or Wi-Fi signals based on RF bandwidth
Interference Mapping Draw multiple bearings of signal strength from GPS location on on-screen map
Pan and Zoom on-screen maps
Support for MA2700A Handheld Interference Hunter (see Optional Accessories)
Application Options Bias-Tee (On/Off), Impedance (50 Ω, 75 Ω, Other)
Channel Scanner (Option 0027)
General Number of Channels 1 to 20 Channels (Power Levels)
Measurements Graph/Table, Max Hold (On/5 sec/Off), Frequency/Channel, Current/Maximum, Dual Color
Scanner Scan Channels, Scan Frequencies, Scan Customer List, Scan Script Master™
Amplitude Reference Level, Scale
Custom Scan Signal Standard, Channel, # of Channels, Channel Step Size, Custom Scan
Frequency Range 150 kHz to 7.1 GHz
Frequency Accuracy ± 10 Hz + time base error 4
Measurement Range –110 dBm to +30 dBm
Application Options Bias-Tee (On/Off), Impedance (50 Ω, 75 Ω, Other)
Gated Sweep (Option 0090)
General Mode Spectrum Analyzer, Sweep
Trigger External TTL
Setup Gated Sweep (On/Off)
Gate Polarity (Rising, Falling)
Gate Delay (0 ms to 65 ms typical)
Gate Length (1 µs to 65 ms typical)
Zero Span Time
Zero Span IF Output (Option 0089)
General Mode Spectrum Analyzer/Span/Zero Span
Center Frequency 140 MHz ± 130 kHz
Output Level –25 dBm typical
Reference Level –57 dBm to +30 dBm (Preamp Off)
–87 dBm to –40 dBm (Preamp On)
IF Bandwidth Up to 30 MHz (3 dB bandwidth)
RF Attenuation Auto
Connector BNC female
4. time base error = frequency accuracy x measured frequency