Atec Anritsu-MT8220T User Manual
Page 2
PN: 11410-00698 Rev. B
MT8220T TDS
Specifications
BTS Master™ MT8220T
Cable and Antenna Analyzer
Measurements
Measurements
VSWR, Return Loss, Cable Loss, Distance-to-Fault (DTF) VSWR, Distance-to-Fault (DTF) Return Loss,
1-port Phase, 2-port Phase , 2-port Gain, Smith Chart
Setup Parameters
Frequency
Start/Stop, Signal Standard, Start Cal
DTF
Start/Stop, DTF Aid, Units (m/ft), Cable Loss, Propagation Velocity, Cable, Windowing
Windowing
Rectangular, Normal Side Lobe, Low Side Lobe, Minimum Side Lobe
Amplitude
Top, Bottom Auto Scale, Full Scale
Sweep
Run/Hold, Single/Continuous, RF Immunity (High/Low), Data Points, Averaging/Smoothing, Output Power
(High/Low)
Data Points
137, 275, 551
Markers
Markers 1 to 6 each with a Delta Marker, Marker to Peak/Valley, Marker Table (On/Off), All Markers Off
Traces
Recall, Copy to Display Memory, No Trace Math, Trace ± Memory, Trace Overlay (On/Off)
Limit Line
On/Off, Single Limit, Multi-segment Edit, Limit Alarm (On/Off), Pass Fail Message (On/Off), Warning Limit
Offset, Clear Limit
Limit Line Edit
Frequency, Amplitude, Add Point, Delete Point, Next Point Left, Next Point Right, Move Limit
Calibration
Start Cal, 1/2-port, Low/High Power, Standard/FlexCal™, DUT Connector, Configure DUT
Save/Recall
Setups, Measurements, Screen Shots (JPEG - save only)
Application Options
Bias-Tee (On/Off)
Frequency
Frequency Range
400 MHz to 6 GHz
Frequency Accuracy
± 3.0
×
10
–6
Frequency Resolution
1 kHz (RF immunity low)
100 kHz (RF immunity high)
Output Power
High
–7 dBm, typical, 1 or 2-port
Low
–40 dBm, typical, 2-port
Dynamic Range (output power high, 25-trace average)
400 MHz to 2800 MHz
> 100 dB, 110 dB typical
> 2800 MHz to 4000 HHz
> 90 dB
> 4000 MHz to 6000 MHz
> 85 dB
Interference Immunity
On-Channel
+17 dBm @ >1.0 MHz from carrier frequency
On-Frequency
+10 dBm within ±10 kHz from the carrier frequency
Measurement Speed
Return Loss
≤ 4.5 ms/data point, RF immunity low, typical
Distance-to-Fault
≤ 4.5 ms/data point, RF immunity low, typical
Return Loss
Measurement Range
0 to 60 dB
Resolution
0.01 dB
VSWR
Measurement Range
1:1 to 65:1
Resolution
0.01
Cable Loss
Measurement Range
0 to 30 dB
Resolution
0.01 dB
2-Port Gain
Measurement Range
–120 to 100 dB
Resolution
0.01 dB