Atec Agilent-N4010A - Manual (Page 2)

2
Bluetooth Specifications
N4010A Option 101 Bluetooth
• Provides ability to act as a Bluetooth master, perform
inquiry, and establish a connection in test mode or
normal mode
• Makes measurements in accordance with Bluetooth RF
Test Specification 1.2
• Integral sequencer allows test plans to be created and
edited easily
• All tests default to SIG standard settings – user may
change settings to match particular test requirements
Bluetooth tests 1
Output power
Link conditions
Link mode Test mode (loopback, Tx), normal
mode (ACL, SCO)
Hopping 2 On or off
Packet type 2 DH1, DH3, DH5, HV3
Payload 2 PRBS9, BSOO, BSFF, BSOF, BS55
Measurement
Supported measurements Average power, peak power
Number of measurement
channels 3
3
Range +23 to –70 dBm
Measurement resolution 0.01 dB
Measurement accuracy ±0.5 dB
Power control
Link conditions
Link mode Test mode (loopback, Tx)
Hopping On or off
Packet type DH1, DH3, DH5, HV3
Payload PRBS9, BSOO, BSFF, BSOF, BS55
Measurement
Supported measurements Average power, min/max step size
Number of measurement
channels 3
3
Range +23 to –70 dBm
Measurement resolution 0.01 dB
Measurement accuracy ±0.5 dB
Modulation characteristics
Link conditions
Link mode Test mode (loopback, Tx), normal
mode (ACL, SCO)
Hopping 2 On or off
Packet type 2 DH1, DH3, DH5, HV3
Payload 2 BS55, BSOF
Measurement
Supported measurements Min/max ∆f1
avg
, min ∆f2
max
(kHz),
total ∆f2
max
> ∆f2
max
lower limit
(%) min of min ∆f2
avg
/ max ∆f1
avg
,
pseudo frequency deviation (∆f1
and ∆f2) in normal mode
Number of measurement
channels 3
3
RF input level range +23 to –70 dBm
Deviation range –400 to +400 kHz
Deviation resolution 100 Hz
Ratio resolution 0.1%
Measurement accuracy 4 As frequency reference ±100 Hz
1. Performance of the N4010A signal source or signal analyzer over
wider temperature (specified later in this document) applies to all
Bluetooth tests listed.
2. Normal mode measurements made with hopping on, NULL packet,
and no payload.
3. Internal sequencer enables three measurement channels to be
measured consecutively. Measurements on all 79 Bluetooth channels
are supported.
4. Example, using the 10 MHz reference with accuracy of 10 Hz (1 ppm),
at frequency of 2.402 GHz, frequency accuracy would be in the range
of ±((2.402 GHz x 10 Hz)/10 MHz) ± 100 Hz = ±2402 Hz ± 100 Hz =
±2502 Hz.