Alpha Technologies APB HFC Voltage Booster - Manual (Page 12)

016-559-B0-001 Rev. A 12
Fig. 2-3, Coaxial Cable Connector
2.0 Installation, continued
2.3 Cable Preparation
Tools Required:
• Wire Cutters
• Open-End wrenches (refer to manufacturer’s assembly instructions)
This section is for reference only; follow instructions provided by the connector’s manufacturer.
NOTE:
Coaxial cables may carry AC power. To avoid possible shock or damage to the
equipment, always handle coaxial cables with extreme caution. Always install coaxial
connectors with the RF module removed from the enclosure.
WARNING!
Procedure:
1. Assemble coaxial connectors with no more than 13 inches between ends.
2. Cut the pin length as shown on the following page.
1-7/16"
to
1-5/8"