Alpha Technologies CFR Intelligent Interface Device - Manual (Page 7)

7. APPENDIX
41
1. INTRODUCTION
Unpacking and Inspection
The Intelligent Interface Device, standard with the CFR 7.5K, CFR 10K,
and CFR 15K, requires no installation. It is optional on all other CFR units
and comes either factory installed or as a user-installable kit. Note: The
Intelligent Interface Device is not user-installable on the CFR 600 or CFR
1000. If the unit is going to be used in a remote application, it simply plugs
into the MMJ connector located on the back of all CFR units.
If ordered separately, carefully remove the Intelligent Interface Device Kit
from its shipping container. Inspect the contents. If items appear to be
damaged or missing, contact Alpha Technologies and the shipping company
immediately. Most shipping companies have only a short claim period. Make
sure the following items have been included:
1. Intelligent Interface Device
2. Operator's Manual
3. Any other ordered options (i.e., interface cables, etc.)
SAVE THE ORIGINAL SHIPPING CONTAINER.
In the event the unit needs to be returned for service, it should be
packaged in its original shipping container. If the original container is not
available, make sure that the unit is packed with at least three inches of
shock-absorbing material to prevent shipping damage. Note: Do not use
popcorn-type material. Alpha Technologies is not responsible for damage
caused by the improper packaging of returned units.
PLEASE READ THE OPERATOR'S MANUAL.
Become familiar with the Intelligent Interface Device by reviewing the
drawings and illustrations contained in the manual before proceeding. If you
have questions regarding the safe installation or operation of the unit, contact
Alpha Technologies.
The menu items outlined in this manual can be accessed by pressing the
keys on the keypad of the Intelligent Interface Device, or from a remote
terminal. The numbers contained in this guide will act as a quick reference to
accessing menu functions. Single-digit numbers relate to specific main
menus. Double-digit numbers relate to specific sub-menus.
Remote Terminal Quick Reference
iv
1 SYSTEM PARAMETERS
EFFICIENCY
BATTERY TEMPERATURE
11 START TEST
12 STOP TEST
2 INPUT PARAMETERS
VOLTAGE
CURRENT
VOLT AMPS
POWER IN WATTS
POWER FACTOR
LINE FREQUENCY
3 OUTPUT PARAMETERS
VOLTAGE
CURRENT
VOLT AMPS
POWER IN WATTS
POWER FACTOR
LINE FREQUENCY
4 BATTERY PARAMETERS
41
VOLTAGE
42 CHARGER CURRENT
43 CHARGER STATUS
5 USER PARAMETERS
51
SET TIME
52 SET DATE
SET TEST SCHEDULE
53 SET TEST START TIME
54 SET TEST START DATE
55 SET TEST FREQUENCY
56 SET TEST DURATION
57 BATTERY AH CAPACITY
58 SET USER / HISTORY SECURITY CODE
59 SET MAINTENANCE SECURITY CODE
IID SOFTWARE VER. CFR SOFTWARE VER.
MICROBD SER. NO. EEPROM VERSION NO.
POWERBD SER. NO. IID SERIAL NO.
501 SET MODEM PHONE NUMBER (ATDT18003225742)
502 SET PAGER ID STRING (7589210)
503 SET MODEM MESSAGE STRING
6 HISTORY LOGS
61
DISPLAY EVENT HISTORY
62 CLEAR EVENT HISTORY
7 MAINTENANCE PARAMETERS
71 FAST DETECT HI REF
72 MEDIUM DETECT LO REF
73 MEDIUM DETECT HI REF
74 SLOW DETECT LO REF
75 SLOW DETECT HI REF
76 SLOW DETECT HYS LO REF
77 SLOW DETECT HYS HI REF
78 MAX. PLL SLEW RATE
79 BATTERY WARNING REF.