Alpha Technologies FBE2322 Enclosure System - Manual (Page 30)

30 031-314-B0-001, Rev. A (12/2012)
2.0 Installation, continued
2.10 Battery Installation, continued
Battery Wiring Procedure:
Fig. 2-18, Inline Fuse Stack Up
Lock Washer
Flat Washer
Ring Terminal
Fuse
Flat Washer
Nut
Bolt (torque to 75in-lbs
on fused terminal)
1. Place batteries in the enclosure with manufacturer’s
specified spacing between each battery.
2. Remove and save Battery Terminal Covers.
3. Connect adjacent batteries with Intercell Bar, see
Fig. 2-17. Where applicable install the Remote
Temperature Sensor.
For further information for battery connections and wiring, see Alpha p/n 031-314-08 Wire
Diagram FBE2322 System.
NOTE:
Fig. 2-19, Example of Completed
Battery Installation
Fig. 2-17, Example of Battery
Stack Up
4. Where applicable, install the Inline Fuse, (see
Fig. 2-18).
5. Replace Battery Terminal Covers.
6. Make final connections to equipment per
manufacturer’s recommendations.
7. Battery installation is now complete (see Fig. 2-19
for example).
-
Nut (torque to
manufacturer's
specifications)
Lock Washer
Flat Washer
Remote Temp. Sensor
Intercell bar
+