Extron Electronics System 5cr - Manual (Page 15)

Chapter 2 • Making Connections
Extron • System 5cr Switcher • User’s Manual 2-4
Audio Preamp Out Connection
Connect balanced or unbalanced, 2-channel audio to the Preamp Out
connector marked L (Left) and R (Right), using a captive screw connector.
Possible connections are shown in Figure 2-6. Connectors are included
with each System 5, however, cables are the responsibility of the installer.
Use the same procedure as for the audio input captive screw connectors.
Figure 2-6. Audio Preamp Output can be connected three different ways.
Connecting Accessories
The System 5 can have several options and accessories that use
connectors in the rear panel. Figure 2-7 shows four of the captive screw
connectors for the Room Relay, IR Emitter or IR Broadcaster and the two
SCP 100 remote panels. There is also one round connector for an
optional Display power Sensor. Each accessory product has its own
user’s manual and is also summarized in Appendix B of this manual.
Figure 2-7. System 5 accessory and option connections.
To IR Broadcaster
To projector remote jack