Extron Electronics VSW 2VGA A User Guide - Manual (Page 24)

VSW 2VGA A • Installation and Operation
Installation and Operation, cont’d
2-14
Operation
Apply power and the input signals. The video and audio
output connectors, including the Loop Thru Input 1 connector,
should output signals.
Input selection
There are three ways to select between Input 1 and Input 2:
• Toggle the front panel input select switch up (Input 1) or
down (Input 2).
• Use the rear panel contact closure capability.
• Press the Show Me button on the VSW I AAP to select the
input on the connected VSW 2VGA A switcher.
Using the VSW I AAP
The VSW I AAP can be used on the inputs of a single switcher
or on the inputs of multiple switchers in a daisy chain
configuration.
Setting the VSW I AAP jumpers
A jumper on the VSW I AAP may need to be shifted from
jumper J6 (the default position) to J5, depending on the
application. See the following illustration and table.
J5 J6
Jumper installed
J6
J5
Switcher compatibility
VSW 2VGA A (Input 1)
VSW 2VGA A (Input 2)
Single switcher example
The following illustration is an example of a single switcher
configuration.