Extron Electronics VSW 2VGA A User Guide - Manual (Page 17)

VSW 2VGA A • Installation and Operation 2-7
3. Attach the through-desk mounting brackets
(MBD 129, part #70-077-02) to the VSW 2VGA A with the
four provided machine screws, as shown in the through-
desk mounting diagram on the next page.
4. Hold the switcher with attached brackets up against the
underside of the desk or table. Use a soft pencil to mark
the locations of the holes for the screws that will attach the
brackets to the desk.
5. Drill 1/4 inch (6 mm) deep, 3/32 inch (2 mm) diameter
pilot holes in the desk or table at the marked screw
locations. The holes should be drilled from the underside
or inside (concealed side) of the furniture, where the
switcher will be located.
6. Attach the switcher to the desk or table with the provided
wood screws, as shown in figure 2-4.
VSW
2VG A A
INPU T 1
21
INPU T 2
Figure 2-4 — Through-desk mounting
7. To adjust the height of the switcher within the desk,
slightly loosen the screws that attach the brackets to the
switcher, adjust the height by sliding the switcher up or
down, and retighten the screws.