Extron Electronics SW DVI A Series User Guide - Manual (Page 9)

SW DVI A Series • Installation
Installation, cont’d
2-4 SW DVI A Series • Installation 2-5
Use 2 mounting holes on
opposite corners. (2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
HalfRackVersaToolsStandardShelf
1/2 Rack Width Front False
Faceplate
3
2
4
Mounting an SW DVI A switcher on a standard
9.5-inch deep rack shelf
Back of the rack mounting
The SW DVI A series can also be mounted vertically to the front
or rear rack supports, using the optional MBB 100 Back of the
Rack Mounting Kit (part #70-367-01) as follows:
1
. If rubber feet were previously attached to the bottom of the
unit, remove them.
2 . Remove the two screws from one side of the switcher.
Retain the screws for possible later reassembly.
3 . Attach one bracket to the side of the unit, using the longer
screws included in the mounting kit (see the illustration on
the next page).
Mounting on a standard or VersaTools rack shelf
1 . If feet were previously attached to the bottom of the
SW2/SW4, remove them.
2 . Mount the SW DVI A Series switcher on the rack shelf,
using two 4-40 x 3/16" screws in opposite (diagonal)
corners to secure the unit to the shelf (see the figures below
and on the next page).
3 . Install blank panel(s) or other unit(s) on the rack shelf as
desired.
4 . Install the shelf in the rack.
The following illustrations show examples of how the
SW2/SW4 can be mounted on different sized rack shelves.
HalfRackVersaToolsShelf
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/2 Rack Width Front
False Faceplate
2
3
4
Mounting an SW DVI A switcher on a 3.5-inch deep
VersaTools rack shelf