Extron Electronics SW DVI A Series User Guide - Manual (Page 10)

SW DVI A Series • Installation
Installation, cont’d
2-6 SW DVI A Series • Installation 2-7
Furniture mounting
To mount the SW DVI A switcher under a desk, table, or
podium, use the optional VersaTools MBU 123 Mini Under-Desk
Mounting Kit (part #70-212-01), as follows:
1
. If rubber feet were previously attached to the bottom of the
unit, remove them.
2 . Remove the two screws from one side of the SW2/SW4.
Retain the screws for possible later reassembly.
3 . Attach one bracket to the side of the unit, using the
provided machine screws.
Preparing the SW2/SW4 for under-desk mounting
4 . Repeat steps 2 and 3 on the other side of the SW2/SW4.
5 . Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the brackets’ screw holes.
6 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep, into the mounting surface at the marked screw
locations.
7 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
8 . Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9 . Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
Attaching the back of the rack mounting brackets to
the SW2/SW4 switcher
4 . Repeat steps 2 and 3 on the other side of the unit.
5 . Mount the switcher to the rack support, using the two
included rack screws.
MAV SER IES AV MA TRIX SWITCHER I/O
AUD
AUDIO SETU P
PRESET
VID
IR
+dB
-dB
ENTER
2
7
6 5
2
4
1
INPU TS
OUT PUT S
8
3
1
8
6
5
4
3
7
Mounting the SW2/SW4 to a back of the rack support