Extron Electronics SW DVI A Series User Guide - Manual (Page 23)

SW DVI A Series • Specifications, Part Numbers, Accessories
Specifications, Part Numbers, Accessories
SW DVI A Series • Specifications, Part Numbers, Accessories A-2 A-3
Audio input
Number/signal type ..................... 2 or 4 stereo, unbalanced
Connectors ..................................... (2 or 4) 3.5 mm mini audio jacks
(tip = L, ring = R, sleeve = GND)
Impedance ...................................... >10k ohms unbalanced, DC coupled
Nominal level ................................ -10 dBV (316 mVrms)
Maximum level .............................. +8.2 dBV, unbalanced at 1% THD+N
N 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0dBV 2dBu
Audio output
Number/signal type ..................... 1 stereo, balanced/unbalanced
Connectors ..................................... (1) 3.5 mm captive screw, 5-pole
Impedance ...................................... 50 ohms unbalanced, 100 ohms balanced
Maximum level (Hi-Z) ................. >+16.5 dBu, balanced;
>8.2 dBV, unbalanced at 1% THD+N
Maximum level (600 ohm) ........... >+10.4 dBm, balanced;
7.1 dBm, unbalanced at 1% THD+N
Control/remote
Serial control port .......................... (1) RS-232, 3.5 mm captive screw
connector, 5-pole (shared with
autoswitching control)
Baud rate and protocol ................. 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations . 1= TX, 2 = RX, 3 = GND
Contact closure .............................. (1) 3.5 mm captive screw connector, 5-pole
(shared with RS-232)
Contact closure pin configurations
Pins 4 and 5 shorted together enable
autoswitch mode.
IR remote control ........................... IR 102 Remote Control
(#70-224-10, optional)
Program control ............................. Extron’s Simple Instruction Set (SIS ™ )
General
External power supply ................. 100 VAC to 240 VAC, 50/60 Hz, external;
to 12 VDC, 1 A, regulated
Power input requirements ........... 12 VDC, 0.7 A
Temperature/humidity ................ Storage: -40 to +158 °F (-40 to +70 °C) /
10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) /
10% to 90%, noncondensing
Cooling ........................................... Convection, no vents
Specifications
Video
Video amplifier bandwidth ......... 1.65 Gbps
Pixel clock frequency .................... 24 MHz to 165 MHz
Impedance ...................................... 100 ohms
Resolution....................................... Up to 1080p (HDTV) or 1920x1200
(highest resolution of the single link DVI
standard @ 60 Hz)
Video input
Number/signal type ..................... 2 or 4 single link DVI-D digital component
video, 1920x1200 @ 60 Hz maximum
resolution
Connectors ..................................... 2 or 4 female DVI-I
Nominal levels
Digital video ...................... 1.2 Vp-p
DDC (Display Data Channel)
TTL: 5.0 Vp-p
Equalization ................................... +6 dB or +12 dB, switch selectable for each
input
Video output
Number/signal type ..................... 1 DVI-D digital component video,
1920x1200 @ 60 Hz maximum resolution
Connectors ..................................... 1 female DVI-I
Audio
Gain ................................................. Unbalanced output: +0dB;
Balanced output: +6 dB
Frequency response ...................... 20 Hz to 20 kHz, ±.05 dB
THD + Noise .................................. 0.01% @ 1 kHz at nominal level
S/N .................................................. >90 dB at maximum output (unweighted)
Crosstalk ......................................... <-45 dB @ 20 kHz;
-72 dB @ 1 kHz or below
Stereo channel separation ............ >80 dB @ 20 Hz to 20 kHz