Extron Electronics TP T Series Transmitters User Guide - Manual (Page 10)

Introduction, cont’d
TP T Series Transmitters • Introduction 1-4
PRELIMINAR
Y
Output — An RJ-45 connector provides a connection to an Extron TP R receiver.
Horizontal shift — Allows you to adjust the horizontal placement of the computer
video image on the screen. This is also called “horizontal centering”.
DDSP ™ (Digital Display Sync Processing ™ ) — Allows the sync signal to pass through
without altering sync pulse timing or width.
TP T 15HD AV transmitter
Video inputs —
Computer video — Accepts computer analog video on a female 15-pin HD
connector. With an adapter cable, the transmitter can accept a Macintosh
video, 13W3 video, or RGBHV, RGBS, RGsB, component video, S-video, or
single source composite video input.
N Only bi-level sync is supported with component video.
Composite video — Accepts NTSC, PAL, and SECAM composite video on an RCA
jack.
Audio input — Accepts PC audio on a 3.5 mm stereo mini jack, and stereo audio on
two RCA jacks.
Outputs — Two RJ-45 connectors provide connections to a TP RGB video receiver and
a TP composite video receiver:
Buffered local monitor output — Allows you to view the displayed computer
video image on a local monitor that is located up to 100 feet from the
transmitter, without signal reflections or crosstalk.
Horizontal shift — Allows you to adjust the horizontal placement of the computer
video image on the screen. This is also called “horizontal centering”.
DDSP ™ (Digital Display Sync Processing ™ ) — Allows the sync signal to pass through
without altering sync pulse timing or width.
TP T BNC DA4 transmitter/distribution amplifier
Video input — Accepts RGBHV, RGBS, RGsB, component, and composite video
on BNC connectors. With an adapter cable, the transmitter can also accept an
S-video input.
N Only bi-level sync is supported with component video.
Outputs — Four individually isolated, buffered, and amplified outputs on RJ-45
connectors allow connection to up to four Extron TP receivers.
Compatibility between products
The TP T 15HD AV is backward compatible with the TP T 15HD A and the
TP T BNC DA4. However, the TP T 15HD A and the TP T BNC DA4 (products
whose part numbers end in -02) are not forward compatible with the TP T 15HD AV
(whose part number ends in -03).