Extron Electronics TP Receivers User Guide - Manual (Page 28)

TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-16
Power connector
i
Power
TP R BNC AV — Plug a standard IEC power cord into this
connector to connect the TP R BNC AV to a 100 to
240 VAC, 50-60 Hz power source.
N If the distance between the transmitter and receiver is too
great for the receiver to power the transmitter, the video
image will be missing, distorted, noisy, or the receiver
Manual/Auto LED will flash. The transmitter will
require a local power supply.
TP R BNC A — Wire the external 15 V power supply into
this 3-pole captive screw connector (figure 2-9) and
plug the connector into the receiver. The power
supply is included with the unit.
SECTION A–A
Power Supply
Output Cord
Ridges Smooth
A A
TP R 15HD A
3/16”
(5 mm)
Max.
TP R BNC A
N/C
N/C
Figure 2-9 — Power connector wiring
TP R 15HD A — Wire the external 15 V power supply
into this 2-pole captive screw connector (figure 2-9)
and plug the connector into the receiver. The power
supply is included with the unit.