Extron Electronics TP Receivers User Guide - Manual (Page 16)

TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-4
Video jumpers
The TP R BNC A and TP R BNC AV receivers can be configured
to receive component video (bi-level sync only), S-video, or
composite video.
N The receivers are factory configured for RGB video. To
receive any other type of video, reconfigure the jumpers.
1 . Remove the three screws on each side and the two screws
on top of the cover (figure 2-1).
RGB
Bottom PC board (inside case)
TP R BNC A and TP R BNC AV
For TP R BNC AV
Remove Video (top) board
J3
1
2
3
J3
U25
Component,
S-video,
Composite
J3
1
2
3
J3
RGB OUTPUT
RGB INPUT
A-V INPUT
A-V OUTPUT
AUDIO
R
VIDEO
G
B
H/HV
V
A
AUDIO
L
R
B
A
L
R
B ISOG C SYNC
50/60 Hz
100-240V
1.3A Lift Cover
Straight Up
TP R BNC AV
Remove 8
Screws
Remove 5 ( TP R BNC A)
or 6 ( TP R BNC AV)
BNC Hex Nuts
Figure 2-1 — Video jumper configuration
2 . Using an Extron BNC extraction tool (part #100-096-01) or a
14 mm, deep well socket with thin walls, remove the five or
six hex nuts securing the BNC connectors to the rear panel.
3 . Slide the cover to the rear until the cover clears the BNC
connectors and then lift the cover off.
4 . TP R BNC AV only : Remove the four screws securing the
video board to the RGB board and lift the video board out
of the way.