Extron Electronics TP Receivers User Guide - Manual (Page 21)

TP Receivers • Installation and Operation 2-9
TP R 15HD A only — For optional rack mounting, mount the
receiver on a Rack Shelf Kit for 3.5 inch deep products (Extron
part #60-190-20), figure 2-4. The TP R 15HD A mounts in one of
four locations on the rack.
(2) 4-40 x 3/16" screws
Use 2 Mounting Holes on
Opposite Corners
3.5” Deep Rack Shelf
1/4 Rack Width False Front
Face Plate
TP R
15H D A
RGB
PEA KIN G
LEV EL
TP R
15H
D A
RGB
PEA KIN G
LEV EL
TP R
15H D A
RGB
PEA KIN G
LEV EL
Figure 2-4 — Rack mounting the TP R 15HD A
1 . If feet were previously installed on the bottom of the
receiver, remove them.
2 . Mount the receiver on the rack shelf, using two
4-40 x 3/16 inch screws in opposite (diagonal) corners to
secure the receiver to the shelf.
3 . Install blank panel(s) (included universal rack kit, optional
for the basic rack kit) or other unit(s) to the rack shelf.
N Only the TP R 15HD A can be mounted on a 3.5 inch
deep shelf. Any 1U rack-mountable Extron product can
be mounted on the standard shelf.