beautypg.com

Output cabling, Computer video – Extron Electronics TP Receivers User Guide User Manual

Page 25

background image

TP Receivers • Installation and Operation

2-13

b

Composite video input connector — Attach one end of a TP

cable to this RJ-45 female connector. Attach the other end to an

Extron TP video transmitter outputting composite video. See

Termination of TP cable

on page 2-17 for pin assignments.

Output cabling

Computer video

The TP R BNC A, TP R BNC AV, and TP R 15HD A receive and

output RGB video. These receivers can also receive component

(bi-level sync only) video, S-video, or composite video and

output them on the R, G, and B signal lines.
Reception of bi-level component video, S-video, or composite

video requires an internal jumper (TP R BNC AV and TP R BNC)

or external DIP switch (TP R 15HD A) be repositioned. See

“Video jumpers” or “Video DIP switch” earlier in this chapter.

c

RGB Output BNCs (TP R BNC A and TP R BNC AV)

Connect the desired video output device to the rear panel

output BNCs:

For RGBHV video, use the R, G, B, H/HV, and V BNCs.

R

G

B

H/HV

V

For RGBS video, use the R, G, B, and H/HV BNCs.

R

G

B

H/

HV

V

For RGsB or component video, use the R (R-Y), G (Y), and B

(B-Y) BNCs.

R

G

B

H/HV

V

For S-video, use the R (C-chroma) and G (Y-luma) BNCs.

R

G

B

H/HV

V

For composite video, use the R, or G, or B BNC.

R

-or-

-or-

G

B

H/HV

V

N

The H/HV and V BNCs output sync, not video signals.