Extron Electronics PVT SW RGB - Manual (Page 16)

2-4
Installation, cont’d
PVT Series (Rack Mount Models) • Installation 2-5 PVT Series (Rack Mount Models) • Installation
Furniture mounting
Use the optional mounting kit (MBU 123, under desk mounting
kit, part #70-212-01) to mount the PVT as follows:
1
. If installed, remove the feet from the bottom of the PVT.
2 . Attach the mounting brackets to the PVT with the machine
screws provided (figure 2-3).
Figure 2-3 — Mounting the PVT under a desk
3 . Hold the PVT with the attached brackets against the
underside of the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4 . Drill four 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked locations.
5 . Insert #8 wood screws into the pilot holes. Tighten the
screws until just less than 1/4" of the head protrudes.
6 . Align the mounting screws with the slots in the brackets
and place the PVT against the surface, with the screws
through the bracket slots.
7 . Slide the PVT slightly forward or back, then tighten all
four screws to secure the PVT in place.
To rack mount a PVT transmitter, do the following:
1
. If installed, remove the feet from the bottom of the PVT.
2 . Mount the PVT using two 4-40 x 3/16" screws in opposite
(diagonal) corners to secure the PVT to the shelf.
3 . Install blank panel(s) or other unit(s) to the rack shelf.
VersaTools
Rack Shelf
(2) 4-40 x 3/16"
Screws
Quarter and Eighth
Rack Width False
Front Face Plate
Quarter Rack
Width Device
Eighth Rack
Width Device
Figure 2-1 — Mounting the PVT on a VersaTools rack
shelf
MDA SER
IES
DIST RIBU TION AMP LIFIE R
Quarter Rack
Width Device
Eighth Rack
Width Device
Figure 2-2 — Mounting the PVT on a standard rack
shelf