Extron Electronics MLC 52 Series Quick Start Guide - Manual (Page 8)

MLC 52 Series Quick Start Guide, cont’d
MLC 52 Series • Quick Start Guide 6
VOL/
MUTE
10V
MPA 122
or MPA 181T
Remote Port
10V
1 2 3
VOL
MLC 52 VC potentiometer
Rear Panel
10V
VOL
Wiring the VC potentiometer to the MPA remote volume control port
Step 4
Attach cables to the projector and, optionally, the IR Link, the IR Emitter, and/or
the IRL 20.
Step 5
Connect power cords and turn on all the devices , including the MLC.
Step 6
Configure the controller by using one of the following methods:
• IR Learning (See “Configuring using IR Learning,” later in this guide.)
• IR Data Transfer (“beaming”) (See “Configuring using IR data transfer
(“beaming”),” later in this guide.)
• Windows ® -based configuration software (Refer to chapter 5, “Serial
Communication,” in the MLC 52 User’s Manual, for detailed procedures for
using the configuration software.)
Step 7
Test the system. Press the MLC’s buttons, watch the display, and listen to the
audio output.
Step 8
Mount the MLC to the wall or furniture.
a. Disconnect the MLC’s power supply at the power source end (not at the MLC
end).
b. Disconnect the other devices’ power.
c. Secure the faceplate onto the electrical wall box, mounting bracket, wall, or
furniture. (Refer to “Mounting the MLC 52,” in chapter 2, “Installation,” of
the MLC 52 User’s Manual.)
d . Restore power to the MLC and all connected devices.