Installing the software, Operations, Powering the projector/display on and off – Extron Electronics MLC 52 Series Quick Start Guide User Manual
Page 14: Powering on, Mlc 52 series quick start guide, cont’d, Mlc 52 series • quick start guide 12
MLC 52 Series Quick Start Guide, cont’d
MLC 52 Series • Quick Start Guide
12
6 feet
(1.8 m)
Part #70-335-01
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin
D
Connection
TRS
Plug
Pin 2
Computer's RX line
Tip
Pin
3
Computer's
TX
line
Ring
Pin 5
Computer's signal ground
Sleeve
Computer
MLC 52
To Front Panel
Config Port
MLC 52
DISPLAY
ON
PC
VIDEO
OFF
VOL
VOL
2.5 mm
Configuration Port
2.5 mm connector cable for the configuration port
The included CD contains the configuration software and various projector/
display drivers. To install and run the MLC 52 Configuration program software,
ensure that your PC meets the following minimum requirements:
• Windows 2000, XP, or higher
• 400 MHz processor
• 32 MB (megabytes) free hard disk space
Extron’s Windows-based configuration software is provided on a CD included
with the MLC, and updates can be downloaded from the Extron Web site
(www.extron.com).
Installing the software
The configuration program requires about 32 MB of hard disk space.
To install the software onto the hard drive:
1
.
Insert the CD ROM into your CD drive. The disk starts automatically.
2
.
If the disk does not start automatically, run LAUNCH.EXE from the CD.
3
.
Follow the instructions that appear on the screen.
By default the installation creates a directory called “MediaLink” on the PC hard
drive, and places the following two icons in it:
•
MediaLnk52.exe (MediaLink Configuration program)
•
MLC 52Wizard.exe (MediaLink Configuration Wizard)
•
MLC 52 DVCM50 Help.chm (MLC 52 and DVCM 50 Help)
Refer to chapter 5, “Serial Communication,” of the MLC 52 User’s Manual,
also included on the CD, for detailed instructions on configuring the MLC
using this software.
Operations
Powering the projector/display on and off
The On and Off buttons on the MLC 52 front panel are used to power the projector
on and off.
Powering on
Press and release the Projector On button to turn the display device’s power on.
The On button blinks for 4 seconds, then remains steadily lit.