Extron Electronics MPX 866 A Setup Guide - Manual (Page 8)

Front Panel Operations
In this chapter, = lit, = unlit, and = blinking.
Creating a Tie
NOTES: • When creating video and audio ties in the low
resolution video group, audio must be redirected
(tied to a different, but corresponding, output than
the video) because there are only audio outputs
1 through 6. In this case, the audio is tied to an
output in the computer video/audio group.
• If the video is tied to output 7, the audio is tied
to output 1.
• If the video is tied to output 8, the audio is tied
to output 2.
• If the video is tied to output 9, the audio is tied
to output 3.
• If the video is tied to output 10, the audio is tied
to output 4.
• If the video is tied to output 11, the audio is tied
to output 5.
• If the video is tied to output 12, the audio is tied
to output 6.
• If you select an input in the low resolution video
input group (inputs 9 through 14), you can only
select outputs in the low resolution video output
group (outputs 7 through 12). The switcher
automatically redirects the audio. This restriction
applies to tying and untying.
Creating a Tie in the Computer Video Group
1. Press and release the Esc button to clear any input LED, output
LED, or control LEDs that may be lit.
2. Press and release the Video and/or Audio I/O button(s) to select or
deselect video and/or audio as desired.
VIDEO AUDIO
Lit when selected
Off when deselected
Lit when selected
Off when deselected
NOTE: Audio (RS-232) or video can be broken away (tied by
itself) by selecting only the Video button or only the
Audio button.
MPX 866 A • Front Panel Operations 7 6 MPX 866 A • Installation