Extron Electronics MPX 866 A Setup Guide User Manual

Page 19

After verifying that the IP address change was successful, enter
and issue the “arp –d” command at the DOS prompt. For example:
arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table
or

arp –d* removes all static IP addresses from the ARP table.

Loading the Start-up Page

NOTES:

•

If your Ethernet connection to the matrix switcher

is unstable, try turning off the proxy server in your
web browser. In Microsoft Internet Explorer, click

Tools > Internet Options > Connections > LAN

Settings, uncheck the Use a proxy server...
box, and then click OK.

•

For details on operating the switcher via HTML pages,

see the "HTML Operation" section in the MPX 866 A
User Guide.

Start the web browser program.

Click in the Address field.

Enter the Matrix IP address in the Address field.

NOTE: 192.168.254.254 is the factory-specified default value

for this field.

Press the keyboard key. The switcher checks whether it is
password-protected.
If the switcher is not password-protected, it checks and
downloads the HTML start-up page. The switcher is ready for
operation via HTML remote control.
If the switcher is password-protected, it downloads the Enter

Network Password page.

NOTE: A User name entry is not required.

Enter the appropriate administrator or user password in the

Password field and click OK.

The switcher downloads the HTML start-up page, shown below.
The switcher is ready for operation via HTML remote control.

MPX 866 A • Remote Control