Extron Electronics MPX 866 A Setup Guide - Manual (Page 13)

NOTE: X! = Input number 00 – maximum number of inputs for your configuration (00 = untied)
X@ = Output number 01 – 12
Command ASCII Command
(Host to Unit) Response
(Unit to Host) Additional Description
Create ties
NOTES: • Video ties cannot be made between the computer video group and the low resolution video group.
• Audio ties can only be made to the computer/audio output group (outputs 1 through 6).
• Video and audio ties between the low resolution video input group and the low resolution video oputput group are
always made with the audio redirected. In such an operation, the switcher automtatically ties the audo to an output in the
computer/audio outputs group (outputs 1 through 6) as follows:
� If video is tied to output 7, audio is tied to output 1. � If video is tied to output 10, audio is tied to output 4.
� If video is tied to output 8, audio is tied to output 2. � If video is tied to output 11, audio is tied to output 5.
� If video is tied to output 9, audio is tied to output 3. � If video is tied to output 12, audio is tied to output 6.
• Commands can be entered back-to-back in a string, with no spaces. For example: 1*1!02*02&003*003%.
• The matrix switchers support 1-, 2-, and 3-digit numeric entries (1*1!, 02*02&, or 003*003%).
• The the & tie command for RGB and the % tie command for video can be used interchangeably.
• The & read tie command for RGB and the % read tie command for video can be used interchangeably.
Tie input X! to output X@ ,
video and audio
X! * X@ ! Out X@ •In X! •All ] (within computer video group)
— or —
Qik
] (within low resolution video group [because of audio redirection])
Tie input X! video and audio to output X@ .
Example 1 (see Notes, above):
Example 2: 1*3!
11*9! Out03•In01•All ]
Qik ]
Tie input 1 video and audio to output 3.
Tie input 11 video and audio to output 9.
Command/Response Table for SIS Commands
15
MPX 866 A • Remote Contr
ol