Extron Electronics DTP T UWP 232_332 D User Guide - Manual (Page 21)

DTP T HWP/UWP 232/332 D Transmitters • Installation and Operation 15
Operation
AUTO SW
CONFIG
IR OUT
HDMI IN
AUDIO IN
S
G
HDCP
1
2
HDMI IN
AUDIO IN
Extron
AUTO SW
CONFIG
IR OUT
HDMI IN
AUDIO IN
S
G
HDCP
1
AUDIO IN
VGA IN
Extron
DTP T HWP 232/332 D
Front Panel DTP T UWP 232/332 D
Front Panel
A
B
C A
B
C
Figure 14. Transmitter LED Indicators
Transmitter LEDs
A Power LEDs — Two-color front panel LEDs on the transmitters light to indicate signal
and power status as follows:
Amber — The unit is receiving power but there is no signal on the associated input.
Green — The unit is receiving power and a signal is present on the associated
input.
NOTE: Both inputs on the transmitters have their own separate LEDs.
B Auto Switch LED — Lights green when auto switch is active (see “Contact” of item C
on pages 9 and 11 ).
C HDCP LEDs — Lights green when HDMI input has been authenticated on the source
device.
System Operation
After the transmitter, the receiver, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, ensure all cables are routed and
connected properly.
NOTES:
• Ensure that the video source and display are properly connected to the transmitter
and receiver pair, and that the transmitter, the receiver, and the display have power
applied before power is applied to the video source. If all other devices are not
turned on before the video source, the image may not appear.
• Input switching can only be performed via auto switching, RS-232, or contact
closure through the rear panel connectors.