Extron Electronics FOXBOX SR HDMI User Guide - Manual (Page 40)

2. If you have not previously updated firmware for the FOXBOX unit, on the Add Device
screen (see figure 30), select the
RS-232 tab.
Figure 30. Add Device Screen
If you have previously updated firmware for this model, click Cancel . The Firmware
Loader window appears. Proceed to step 5.
NOTE: The receiver does not have an Ethernet port. Do not select TCP/IP .
3. From the drop-down menus on the RS-232 screen, select the appropriate Com port
number and baud rate (the default is 9600).
4. Click OK . The Firmware Loader window appears (see figure 313).
5
Figure 31. Extron Firmware Loader Window
5. Select the FOXBOX receiver and click File > Open . The Choose Firmware File screen
appears (see figure 32).
6
6
Figure 32. Choose Firmware File Window
FOXBOX SR HDMI • Remote Control 34