Extron Electronics FOXBOX SR HDMI User Guide User Manual
Page 34
2.
Select the Com port to which your or receiver is connected. Click
OK
. The Signal
Processing Product Control Program window appears (see figure 23).
NOTE: The receiver does not have an Ethernet port. Do not select
TCP/IP
.
Figure 23.
Signal Processing Product Control Program Window
Status area
Figure 24.
Status Area
The status area provides indications of the connection status.
•
HDMI indicator — This indicator is green when the transmitter detects a sync signal on
its HDMI video input. The transmitter reports the status on the fiber cable.
•
Audio indicator — This indicator is green when the transmitter detects an audio
signal above a –35 dB threshold. It returns to unlit if the audio signal drops below the
threshold for 10 seconds. The transmitter reports the status on the fiber cable.
•
Link 1 indicator — This indicator is green when the receiver detects light on the fiber
optic cable connected to the Tx port.
•
Link 2 (Optional) indicator — This indicator is green when the transmitter detects
light on the fiber optic cable connected to the Rx port. The transmitter reports the status
on the fiber cable.
NOTE: The transmitter detects the receiver-Tx-to-transmitter-Rx light. It reports the
status to the receiver via the Tx cable.
If the PC is connected to the receiver and either the primary (transmitter-
Tx-to-receiver-Rx) cable is disconnected or the receiver is in the daisy chain
mode, the Link 2 indicator in the control program will not show green
(detected), whether the transmitter detects the link or not.
FOXBOX SR HDMI • Remote Control
28