Network config tab, Switch configuration – Extron Electronics Dante Controller User Manual
Page 42
Dante Controller User Guide
Copyright © 2013 Audinate Pty Ltd. All rights reserved.
-42-
n
Latency setting
n
Any existing audio routes
Supported devices allow you to 'Clear Config' instead of Factory Reset. Clear Config wipes the same
configuration settings listed above, but allows you to optionally keep the IP settings (i.e. retain the Dante
Redundancy settings, and any static IP addresses currently configured in the
tab).
A reboot is required after clearing the configuration for the changes to take effect. Some devices will allow
you to automatically reboot after clearing the configuration. If this option is not available, a manual reboot is
required.
Network Config Tab
Use the Network Config Tab to toggle supported devices between Redundant and Switched modes, and to
specify static IP addresses for a device's Ethernet ports.