Extron Electronics Dante Controller User Manual

Page 22

Text mode
Original mode

Dante Controller User Guide

-22-

The selected network interface can be changed via the 'interface selection' button

in the Network

View toolbar of Dante Controller, which also brings up this Configure Dante Interfaces dialog box.

Note: You MUST have a standard wired Ethernet network available and connected to use Dante
Controller. Wireless and other non standard wired Ethernet interfaces are NOT shown in this dialog
box, and cannot be selected.

Note: All Dante applications on the same PC or Mac have a shared understanding of which interface
is the primary Dante interface. For example, if you have installed Dante Virtual Soundcard on the
same PC as Dante Controller and a new primary interface is selected from within Dante Virtual
Soundcard, Dante Controller will automatically switch to the newly selected interface and begin
operating on that interface.