Extron Electronics Dante Controller - Manual (Page 35)

Dante Controller User Guide
Copyright © 2013 Audinate Pty Ltd. All rights reserved. -35-
An additional tab, Baseboard, is only available when the Dante device is a module mounted on a Dante
PDK baseboard (and is in SPI Master mode).
Receive Tab
The Receive tab presents information about all channels being received, and able to be received by the
current device. The tab is arranged into two areas
n
Receive Channels: Lists the Rx channels in the left pane of the window. It shows whether or not
they are connected and, if connected, the channel they are connected to and the status of that
connection.
n
Available Channels: On the right pane of the window, lists the Tx channels from other devices that
are available for subscription by the current device.
The Receive Channels view on the left side of the tab contains three fields:
n
Channel: An editable field that lists the receive channel labels for the current device. These can be
edited to change the current label of a receive channel.
n Signal: Supported devices will also show the following channel metering icons, indicating the
presence of audio on subscribed channels:
Channel is either muted, or receiving audio at less than -61dbFS
Channel is receiving audio between -61dbFS and 0dfFS
Channel is clipping
n
Connected To: Lists the Tx channel that the receive channel is currently subscribed to.
n
Status: Lists the status of both primary and secondary subscriptions using the following icons: