E cover (see, Figure 1 – Extron Electronics Cable Cubby 800 User Manual
Page 7
Cable Cubby 300/600/800 • Introduction
2
Figure 1.
Cable Cubby 300S US/domestic Enclosure
The AAP spaces inside the Cable Cubby allow you to customize the enclosure to meet
your unique needs. The split AAPs (included) can store almost any type of cable you might
encounter. The Extron line of passive AAPs allows you to customize the AAP with almost
any kind of pass-through connectivity you may need.
The elevation of the AAPs inside the cubby and the arrangement of the AAPs and the power
outlets are adjustable to suit cable lengths and connector types.
The installed Cable Cubby fits nearly flush within a table or podium top, storing the AAPs
and cables out of the way and out of sight. To access the AAPs and connectors, lift the lid
(see figure
2). Half-moon cutouts in the lid allow you to run cables in or out and then close
the lid. The lid can also be lowered into its recessed position.
Mounted
through a table
or podium
Extron
Cable Cubby 800
Hideaway Cable
Access Enclosure
Audio Cable,
Network Cable
15-pin HD Cable
Figure 2.
Typical Cable Cubby 800 Application
The Cable Cubby 300 is available with either a round or a rectangular top. The other Cable
Cubby models all have rectangular tops only. Preparing the table to install a Cable Cubby
300C (round) requires drilling a hole in the table with a 6-inch hole saw (see
Preparing the table to install a square cubby requires routing a square hole in the table top.
Sheet metal routing templates are available (see “
page
19 for part numbers).