Extron Electronics Cable Cubby 800 - Manual (Page 12)

Cable Cubby 300/600/800 • Installation 7
Preparing the Table with a Hole Saw (Cable Cubby 300C Only)
Prepare the table with a hole saw as follows:
1. On the tabletop or other installation surface, mark the 6 inch circle, then find and mark
the center of the circle.
CAUTION: Risk of injury to the eyes. Wear safety glasses when operating the
drill. Failure to comply can result in eye injury.
2. Using a portable drill with a 6-inch (or 152 mm) hole saw, carefully cut the opening in
the table surface at the desired location (see figure
6). Extron is not responsible for an
improperly positioned Cable Cubby.
ATTENTION: Potential damage to property. Use a portable drill with sufficient
power to handle the 6-inch hole saw. Exercise caution when handling the drill and
hole saw. Take care to protect the mounting surface from damage.
Figure 6. Cutting the Opening with a Hole Saw
Installing the Cables and AAPs
Each Cable Cubby model ships with one or two moveable AAP shelf assemblies.
AAP Shelf Brackets
Each shipped AAP shelf assembly consists of a set of shelf brackets and a number of cable
pass-through (split) AAPs. Depending on the Cable Cubby model, each set of shelf brackets
supports either two-, three-, or four-space AAPs (see figure
7).
Four-Space Shelf Bracket
and Split AAPs
Three-Space Shelf Bracket
and Split AAPs
Two-Space Shelf Bracket
and Split AAPs
Figure 7. Shelf Brackets