beautypg.com

Preparing the table, Preparing the, Table – Extron Electronics Cable Cubby 800 User Manual

Page 10: Figure 4

background image

Cable Cubby 300/600/800 • Installation

5

These strips raise the routing template above the mounting surface to provide room
for the collar of the router, protect the mounting surface, and extend the reach of the
routing template so that it can be clamped to the edge of the surface.

HSA 200

USER

A

C

C

E

S

S

HSA 20

0

CABLE C

UBBY 300

CABLE CU

BBY 300

USER

A

C

C

E

S

S

1/2” x 4” Soft, Finished

Lumber

4 Screws Min.

Routing Area

Width of Mounting Surface

Figure 4.

Preparing the CC 300 Mounting Template

2.

Using four or more short wood screws, secure the mounting template to the lumber
strips.

ATTENTION: Potential damage to property. Do not allow the wood screws to

protrude through the bottom of the wooden strips. Protruding screws will scratch
the table when the template is used.

Preparing the Table

The preferred and recommended method for preparing the table for square Cable Cubby
models is to use the appropriate Extron routing template and a router.
For the Cable Cubby 300C, you may use the routing template and a router or use a 6-inch
hole saw.

ATTENTION: Potential damage to property. The opening in the table for the

Cable Cubby should be cut only by licensed and bonded craftspeople. Exercise care to
prevent scarring or damaging the furniture.

ATTENTION: Potential damage to property. The surfaces of the Cable Cubby

enclosure have screws and other protruding hardware that could damage fine furniture.
Do not rest the enclosure on unprotected furniture.

Alternatively, for any model, you can use a paper cut-out template (see “

Top Plate

Dimensions

” on page

20) and a sabre saw or keyhole saw. However, this method is not

recommended.

This manual is related to the following products: