Extron Electronics DDS 402 - Manual (Page 25)

3-5 Digital Display Scaler • Operation
Display Cycle
2
sec.
2
sec.
2
sec.
2
sec.
2
sec.
Extron Power
on
60-426-01 Input #2 Horz. 00.00 kHz
Vert. 00.00 Hz Output Rate
DDS 402 Version x.xx RGB 1024 x 768 @ 60
Figure 3-3 — LCD power up and default display cycle
Display
Cycle
MENU
MENU
2 sec.
Power
on
2 sec.
MENU
10 sec.
MENU
10 sec.
MENU
10 sec.
MENU
10 sec. 10 sec.
NEXT
Output
Configuration
Input
Configuration
Memory
Presets
Advanced
Configuration
Exit
Menu
Extron
60-426-01
DDS 402
Version x.xx
Figure 3-4 — Menu system flowchart
Adjust and knobs — When in a submenu, rotate the Adjust knob and Adjust
knob to scroll through the submenu options and select a setting. Refer to the
flowcharts in this chapter and to specific sections for explanations on knob
adjustments.
From any menu or submenu, after ten seconds of inactivity, the DDS 402
saves all adjustment settings and times-out to the default LCD display cycle.
Configuration
The DDS 402 can be configured using either the menu system and front panel
controls, the SIS, or the Windows Control program. See chapter 4, Programmer’s
Guide, and chapter 5, Scaler Software.
Use the Menu button to scroll through and select the main menus. Use the Next
button to scroll through the submenus of a main menu for viewing or
configuration.
Input Configuration menu
Figure 3-5 is a flowchart that shows an overview of the Input Configuration menu,
the Input #2 submenu, and the available settings.