beautypg.com

Step 5: completing the installation – Extron Electronics AVTrac (482) User Guide User Manual

Page 21

background image

Step 5: Completing the Installation

At this point, the track and connectivity box must be secured to the floor, the electrical power must be
connected, and the AAP sockets must be populated.

To complete the installation of the AVTrac, follow these instructions:

1.

Lay the cables and power cords flat against
the base track. If necessary, feed excess cable
back into the wall.

2.

Snap the cover track onto the base track.

3.

Before cutting and gluing carpet, remove all
dust and debris with a vacuum cleaner.

Cut the carpet or carpet tiles so that it runs up
to but does not cover the aluminum track (see
the diagram below).

NOTE: Cut the carpet to meet the edge of

the cover track. Do not align the cuts
to the edge of the ramps because
this will leave a gap between the end
of the carpet and the cover track.

Carpet covers ramps
but not track.

AVTrac • Installation

15