Extron Electronics AVTrac (482) User Guide - Manual (Page 17)

7. Lay the base track on the floor in the
prepared location.
Mate the tabs in the side ramps with the
grooves in the base track, and place the end
ramps in position at the end of the track
furthest from the wall.
8. Using the provided masonry bit, drill
5/32 inch diameter by 1 1/2 inch deep
pilot holes into the concrete through the
predrilled mounting holes in the track and
ramps.
9. Secure the track and ramps to the floor
with the provided masonry screws.
NOTE: Do not use the holes that were
drilled to secure the connectivity
box in sub-step 6 of this section.
Tab on side ramp
mates with groove
in base track.
Side Ramp
Base Track
Drill a 5/32” x 1 1/2” deep hole
into concrete.
Supplied Masonry Screws
AVTrac • Installation 11