Xylem VARIO WATERPROOF PH METER - Manual (Page 35)

VARIO pH Operation
35 ba75373e04 07/2006
4.6.4 Timer
The timer function can count down the seconds of a specified time interval
(timer interval) of maximum 59:59 (minutes:seconds). When the specified
timer interval has expired, an alarm signal sounds for one minute and the
display flashes.
Note
If the timer has been stopped you can
z Reset the timer to the adjusted timer interval with < R >.
z Terminate the timer and switch to the measured value display with
<
E >.
1 Display the stopwatch with < U _>.
The U status indicator appears.
The stopwatch is on 00:00.
2 Select the minutes or seconds with < 5 > or < 6 > [<Minutes> or
<Seconds>].
The selected display flashes.
3 Set the timer interval (minutes:seconds) with < > > and < < >.
The stopwatch has been converted to a timer.
4 Confirm the setting with < g >.
5 Start the timer with < g >.
6 If necessary, display the remaining time as an intermediate time with
<
L >.
7 If necessary, stop the timer before the time has expired with < g >
and make it continue with < g >.
8 As soon as the time has expired the alarm signal sounds.
Switch off the alarm signal with <
( >. The timer goes on counting
with a negative sign.
9 Stop the timer with < g >.
C
0 3 5 1
h:min Day.Month
CLR
Ident
pH
mV
d
MEM
CAL
LoBat Lap
RESET
LAP
ESC
0 5 0 9
min:s