Xylem WQL-pH pH DATALOGGERS - Manual (Page 41)

WQL-pH Logging
115 ba75821e01 10/2009
7.2 Setting up a logging job - setting parameters
You can set the following parameters for a logging job (i.e. the job to
determine and record measured values according to your requirements over
a certain period of time):
Tab Setting Setting options
(default setting in bold)
Recording Interval z 1 second, 5 seconds,
10 seconds, 30 seconds
z 1 minute, 5 minutes, 10 minutes,
15 minutes, 30 minutes
z 1 hour, 2 hours, 3 hours,
6 hours, 9 hours, 12 hours,
24 hours
Start z Immediately
(when the setting mode is quit and the
logger is separated from the PC
program)
z
Logger key button
(when the key button at the control
panel of the logger is pressed)
Stop z Time period
(1 hour ... 365 days)
z Memory full
(the loggers stops logging only when
the memory is full, i.e. when 600,000
datasets have been stored)
Measured
value ID You can assign a measured value ID
(consisting of up to 20 alphanumerical
characters, no special characters) e.g.
the name of the measuring site).
Default setting: default
pH/mV Measuring
mode z pH
z mV
Time Automatic
time
adjustment z Yes (date/time for the logger is
automatically synchronized with that
of the PC)
z No
(date/time for the logger is set
manually)