YSI pHotoFlex pH Handheld Colorimeter - Manual (Page 65)

pHotoFlex
®
pH Operation
65 ba76123e01 02/2013
4.8.2 Configuring the RS232 interface
For an error-free data transmission, the RS232 interface should be set
to the same transmission speed (Baud rate) on the pHotoFlex
®
pH and
PC.
You can set the following values for the baud rate on the
pHotoFlex
®
pH : 1200, 2400, 4800, 9600, 19200.
The baud rate is selected in the menu, Configuration / System / Inter-
face / Baud rate.
4.8.3 Selecting the output format of datasets
For downloading data to the interface you can select the output format.
It is selected in the menu, Configuration / System / Interface / Output
format.
The ASCII output format delivers formatted datasets.
The CSV output format delivers datasets separated by ";".
Output format, ASCII
pHotoFlex Ser. no. 12345678
31.10.04 09:56:20
ID: 1
10.01 (pH) AR
25 °C
________________________________________
pHotoFlex Ser. no. 12345678
31.10.04 15:48:08
ID 1 / PROG 2
1.1 mg/l Pb [BV][9 + 1]
________________________________________
etc...