Analytical Industries GPR-2800 AIS ATEX Oxygen Analyzer - Manual (Page 18)

Advanced Instruments Inc.
18
GAS CONCENTRATION
PERCENT
%
>>> 01.0
SET ALARM 1 VALUE
PRESS UP OR DOWN
TO CHANGE VALUE
ENTER TO SAVE
MENU TO RETURN
GAS CONCENTRATION
PERCENT
%%
>>> 002
SET ALARM 1 VALUE
PRESS UP OR DOWN
TO CHANGE VALUE
ENTER TO SAVE
MENU TO RETURN
10. Press the ENTER key to advance the underline cursor right or press the MENU key to advance the underline cursor left to
reach to the desired digit of the alarm value.
11. Press the ARROW keys to enter the alarm value.
12. Repeat until the complete span value has been entered.
13. Note: If an alarm is set as a PERCENT value and subsequently changed to a % value, the PERCENT value is not retained
and is reset to 00.0. This holds if the alarm was first set as % value and then changed to a PERCENT value.
14. Save the alarm value by pressing the ENTER key or abort by pressing the MENU key.
15. The system returns to the SAMPLING mode and displays:
3.3
%
AUTO SAMPLING
10% RANGE
24.5 C 100 KPA
LO1 2% 10% HI2
Repeat the steps above to set the ALARM 2 value:
MAIN MENU
AUTO SAMPLE
MANUAL SAMPLE
CALIBRATION
CONFIG ALARMS
BYPASS ALARMS
>>>
MAIN MENU
SET ALARM 1
SET ALARM 2
SET ALARM DELAY
ALARM 1 HI/LO
ALARM 2 HI/LO
ALARMS AUDIBLE/SILENT
Set Alarm Delay:
Once the values for ALARM 1 and ALARM 2 have been entered, the user may elect to delay the activation of the local alarms
and relay contacts for up to 99 minutes. This feature allows users to distinguish between transient occurrences and true upset
conditions. This feature can be particularly useful on remote applications without affecting the 4-20mA signal output.