beautypg.com

Software setup, Windows nt 4.0 – Asus V7100 Series User Manual

Page 28

background image

ASUS V7100 Series User’s Manual

28

3. Software Setup

3. S

/W
Setup

Windows NT 4.0

Method 1: Display Property Page

WARNING!

Before installing the display driver in Windows NT 4.0, make sure that

you have installed Windows NT 4.0 Service Pack 3 or later, to take full advan-
tage of the AGP features of your card.
(You may download service packs at
http://www.microsoft.com/ntworkstation/downloads.)

NOTE: The following steps assume your CD-ROM drive letter is D.

1. Start Windows NT, switch display properties to VGA mode (16 colors, 640 x 480

pixels), then restart your computer to make the change.

2. After your computer restarts, right-click the desktop and click Properties.

3. Click the Settings tab.

4. Select Change Display Type.

5. Select Adapter Type and click Change.

6. Click Have Disk.

7. Insert the CD installation disc.

8. Type D:\NT40 or click Browse to select the path of the display driver for Win-

dows NT. Click OK.

9. Select ASUS V7100 and then click OK.

10. Windows NT will once again prompt for confirmation. All appropriate files are

then copied to the hard disk. When all files are copied, go back to the Display
Properties
box by clicking Close. Click Apply.

11. The System Settings Change dialog box is displayed. Click Yes to restart Windows.

12. Windows NT will restart with the default settings. The Display applet will ap-

pear to allow for mode selection.

Display Drivers