Asus M2V-MX SE - Manual (Page 60)

2-18 Chapter 2: BIOS Setup
2.3.6. IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press if you wish to
configure the item.
IDE Configuration
Parallel ATA IDE Controller
[Both]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
Parallel ATA IDE Controller [Both]
Disables or allows selection of the IDE controller. Sets to Primary to enable the primary
IDE controller only. Sets to Secondary to enable the secondary IDE controller only.
Sets to Both to enable both the primary and secondary IDE controllers. Configuration
options: [Disabled] [Primary] [Secondary] [Both]
Hard Disk Write Protect [Disabled]
Disables or enables the devices write protection. This will be effective only when
the device is accessed through BIOS. Configuration options: [Disabled] [Enabled]
IDE Detect Time Out [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration
options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Disabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]