Asus Rampage III Black Edition - Manual (Page 138)

3-42 Chapter 3: BIOS Setup
Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor
Password item on top of the screen shows the default Not Installed. After you set
a password, this item shows Installed.
To set a Supervisor Password:
1. Select the Change Supervisor Password item and press .
2. From the password box, type a password composed of at least six letters
and/or numbers, then press .
3. Confirm the password when prompted.
The message Password Installed appears after you successfully set your
password.
To change the supervisor password, follow the same steps as in setting a user
password.
To clear the supervisor password, select the Change Supervisor Password then
press . The message Password Uninstalled appears.
If you forget your BIOS password, you can clear it by erasing the CMOS Real
Time Clock (RTC) RAM. See section 2.2.8 Jumper for information on how to
erase the RTC RAM.
3.7.3 Security
The Security menu items allow you to change the system security settings. Select
an item then press to display the configuration options.
Hit ‘DEL’ Message Display [Enabled]
When set to [Enabled], the system displays the message “Press DEL to run Setup”
during POST.
v02.61 (C)Copyright 1985-2011, American Megatrends, Inc.
RAMPAGE III BLACK EDITION BIOS Setup Version 0224
Boot
to change
password.
again to
disabled password
←→ Select Screen
↑↓ Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
Security Settings
Supervisor Password :Not Installed
User Password :Not Installed
Change Supervisor Password
Change User Password