Asus GigaX1104PS - Manual (Page 12)

11
GigaX1104PS User's Manual
And both the crossover and straight-through Ethernet cable can be
used to connect the built-in switch and computers, hubs or switches
as the built-in switch is smart enough to be connected with both
types of cables.
2.1.3 Connect the AC Adapter with GigaX1104PS
Plug the rounded connector on the AC adapter cable into the
POWER input jack on the back of GigaX1104PS and plug the AC
adapter in a power outlet or a power strip.
2.1.4 Power on the USB printer, your computers
and/or other LAN Devices
Power on your USB printer, and boot up your computer(s) and/or
any LAN devices such as wireless AP, hubs or switches.
You should verify that the LEDs are illuminated as indicated in Table 2.1.
Table 2.1 LED Indicators
This LED: ...should be:
POWER Solid green to indicate that the device is turned on. If this light
is not on, check whether the AC adapter is attached to the
GigaX1104PS and whether it is plugged into a power outlet.
1 – 4
STATUS
LED
Solid green to indicate that GigaX1104PS is connected with
your LAN; flashing when GigaX1104PS is sending or receiving
data to/from your LAN computer(s).
USB Solid green to indicate that your printer is detected by
GigaX1104PS.
If the LEDs illuminate as expected, GigaX1104PS is working
properly.
2.2 Configure a Static IP Address for Your Computer
The default IP address of the GigaX1104PS is 192.168.1.1. When
initially configure the IP address, you must configure the IP address