Asus P5W - Manual (Page 103)

ASUS P5W -2
DRAM ECC Mode [Disabled]
Allows you to disable or set the DRAM ECC mode. This item appears only when
you install DRAM modules that support ECC function. Configuration options:
[Disabled] [Enabled] [Auto]
Hyper Path 3 [Auto]
Allows you to enable, disable, or set the ASUS Hyper Path 3 feature.
Configuration options: [Disabled] [Enabled] [Auto]
DRAM Throttling Threshold [Auto]
Disables or sets the DRAM Thermal Throttling feature. Set to [Auto] for system
stability. Configuration options: [Disabled] [Auto]
Boot Graphic Adapter Priority [PCI Express/PCI]
Allows selection of the graphics controller to use as primary boot device.
Configuration options: [PCI Express/PCI] [PCI/PCI Express]
PEG Buffer Length [Auto]
Sets the length of the PCI Express graphics card buffer.
Configuration options: [Auto] [Long] [Short]
Link Latency [Auto]
Sets the PCI Express graphics card link latency.
Configuration options: [Auto] [Slow] [Normal]
PEG Root Control [Auto]
Allows you to enable, disable, or set to automatic the PCI Express graphics card
root control. Configuration options: [Auto] [Disabled] [Enabled]
PEG Link Mode [Auto]
Sets the PCI Express graphics link mode. Setting this item to [Auto] allows the
motherboard to automatically adjust the PCI Express graphics link mode to the
correct frequency based on the system configuration. Four additional settings are
available for overclocking the PEG Link Mode. Configuration options: [Auto] [Slow]
[Normal] [Fast] [Faster]
Slot Power [Auto]
Sets the PCI Express graphics card slot power.
Configuration options: [Auto] [Light] [Normal] [Heavy] [Heavier]