Asus P5W User Manual

Page 58

2-2

Chapter 2: Hardware information

3. Intel

ICH7R IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA (133/)100/66 signal cable.

There are three connectors on each Ultra DMA 133/100/66 signal cable:

blue, black, and gray. Connect the blue connector to the motherboard’s IDE

connector, then select one of the following modes to configure your device.

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
• Install devices on this connector (PRI_IDE) first, then install on the

JMicron

IDE connector, PRI_EIDE (see item #2 on the previous page for

the location of the PRI_EIDE connector .

If any device jumper is set as “Cable-Select,” make sure all other device

jumpers have the same setting.

Drive jumper setting

Mode of

device(s)

Cable connector

Single device

Cable-Select or Master

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Black or gray

Slave

P5W

P5W IDE connector

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE