Asus P5N73-CM - Manual (Page 62)

2-22 Chapter 2: BIOS setup
Typematic Rate (Chars/Sec) [6]
Allows you to select the rate at which a character repeats when you hold a key.
Configuration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250]
Allows you to set the delay before keystrokes begin to repeat. Configuration options:
[250] [500] [750] [1000]
Full.Screen.LOGO.[Enabled]
Allows you to enable or disable the full screen logo display feature.
Configuration options: [Disabled] [Enabled]
Halt.On.[All.Errors]
Allows you to error report type. Configuration options: [All Errors] [No Errors] [All, But
Diskette]
2.6.4. Security
Supervisor.Password.. . . . . .
User.Password
These fields allow you to set passwords:
To set a password:
1. Select an item then press .
2.
Type in a password using a combination of a maximum of eight (8) alpha-numeric
characters, then press .
3. When prompted, confirm the password by typing the exact characters again, then
press . The password field setting is changed to Set.
To clear the password:
1.
Select the password field and press twice. The following message appears:
Ensure that the above item is set to [Enabled] if you want to use the ASUS MyLogo2™
feature.
PASSWORD DISABLED !!!
Press any key to continue...
2. Press any key to continue. The password field setting is changed to Clear.
A note about passwords
The Supervisor password is required to enter the BIOS Setup program preventing
unauthorized access. The User password is required to boot the system preventing
unauthorized use.