Asus P5N73-CM - Manual (Page 38)

1-28 Chapter 1: Product introduction
11.. Front.panel.audio.connector.(10-1.pin.AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel
audio I/O module cable to this connector.
• We recommend that you connect a high-definition front panel audio module to this
connector to avail of the motherboard’s high-definition audio capability.
• If you want to connect a high-definition front panel audio module to this connector, set
the Front.Panel.Type item in the BIOS setup to [HD.Audio]..If you want to connect an
AC'97 front panel audio module to this connector, set the item to [AC97]. By default, this
connector is set to [HD.Audio]..See section 2.4.3 Onboard Devices Configuration for
details.
P5N73-CM Azalia Analog Front Panel Connector
R
HP_HD
MIC2_L
HP_R HP_L
MIC2_J
D
Jack_Sens
e
MIC2_R
PRESENSE# AGND
AAFP
Legacy AC’97-compliant
pin definition
NC
MIC2_L
Line out_R Line out_L
NC
NC
MIC2_R
NC AGND
Azalia-compliant
pin definition
P5N73-CM
12.. Floppy.disk.drive.connector.(34-1.pin.FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end
of the cable to this connector, then connect the other end to the signal connector at the
back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when using an
FDD cable with a covered Pin 5.
P5N73-CM Floppy Disk Drive Connector
R
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN1
FLOPPY
P5N73-CM